3
Deutsch
Special functions of your remote control
Adjusting the brightness / colour at your TV:
1. Ensure that your remote control is set to TV (set disk to position
).
2. Press the key.
3. Within 5 seconds, press
for brightness, or
for colour
The LED is now continuously on, indicating that the selected function is
enabled.
4. To adjust brightness or colour, press the and keys.
5. After 10 seconds, your remote control returns to standard mode for the
selection of channels. Alternatively, press the key to reset the device to
standard mode.
AV (input for external devices)
To use the AV function (if supported by your TV) Press and release the key
followed by the key. If your TV has more than 1 AV channel (AV1, AV2, AV3
etc) access to the other channels is accessed by repeating this process. To
come out of AV mode repeat the process until AV is cleared.
Switching channels (c and channel -)
With certain older TV sets, it might not be possible to switch channel using the
and keys. In this case, you must activate the simulated channel switching
function:
1. Press the key of your remote control (for approx. 4 seconds) until the
LED flashes twice.
2. Enter code 1 1 2 2 (i.e. press
). The LED flashes twice.
The simulated channel switching function is now activated. If this function does
not work properly, try the other manufacturer codes for your TV set, or comple-
te a code scan.
To deactivate the simulated channel switching function, proceed as described
for the activation of the function, but enter code 1 1 2 1 (i.e.
) instead
of 1 1 2 2.
It’s useful to write down the 4-digit codes being used for future reference.
This can be useful when changing the batteries or if the batteries fail
whilst away from for long periods.
▲
▲
▲
▲
▲
▲
▲
▲
F
▲
▲
OK
F
F
▲
▲
▲
▲
M
TV
USER MANUAL
GB