6
Celsius / Fahrenheit
•
Press the
DOWN
button (13) to switch between °C and °F
for the temperature display.
6.3 Alarm
Alarm mode
AL
is displayed between the hours and minutes
of the time display.
•
Press the
ALARM
button (8) once to call up alarm mode.
•
Press and hold the
ALARM
button (8) for approximately
3 seconds to set the alarm time. The hours display begins
to flash.
•
Press the
UP
button (12) or the
DOWN
button (13)
to select the hour for the alarm time and confirm your
selection by pressing the
ALARM
button (8). The minutes
display begins to flash.
•
Repeat the process to set the minutes for the alarm time.
•
If you do not make an entry for approximately 5 seconds,
you automatically exit the setting mode.
•
Press the
DOWN
button (13) to activate or deactivate
the alarm. An active alarm is displayed by the alarm
symbol ( ). The alarm symbol goes out when the alarm
is deactivated.
•
If the alarm is triggered, the alarm symbol ( ) will begin
to flash and an alarm will sound.
•
Press any button (except the
SNZ/LIGHT
button (10)) to
stop the alarm. Otherwise, it will stop automatically after
2 minutes.
Note – Snooze function
a
•
While the alarm signal is sounding, press the SNZ/
LIGHT button (10) to activate the snooze function. The
alarm symbol ( ) will start to flash on the display. The
alarm signal will stop for 5 minutes, after which it will
sound again.
•
Press any button (except the SNZ/LIGHT button) to stop
the snooze function and the alarm.
6.4 Maximum and minimum temperature and
humidity values
The base station automatically stores the maximum and
minimum outdoor/indoor temperature and humidity values.
•
Repeatedly press the
UP
button (12) to switch the
display between the current temperature and humidity,
maximum temperature and humidity (MAX) and minimum
temperature and humidity (MIN).
6.5 Backlight
•
Press the
SNZ/LIGHT
button (10) to light up the display
for approximately 5 seconds.
7. Care and Maintenance
• Only clean this product with a slightly damp, lint-free cloth
and do not use aggressive cleaning agents.
• Make sure that water does not get into the product.
8. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.
