2
G
Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions and
information completely. Please keep these instructions
in a safe place for future reference. If you sell the device,
please pass these operating instructions on to the new
owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or
to draw your attention to specific hazards and risks.
Note
This symbol is used to indicate additional information
or important notes.
2. Package Contents
• Power Pack, 5200 mAh
• Micro-USB charging/connecting cable
• These operating instructions
3. Safety Notes
• The product is intended for private, non-commercial
use only.
• Protect the product from dirt, moisture and
overheating, and only use it in a dry environment.
• Keep this product, as all electrical products, out of the
reach of children!
• Do not drop the product and do not expose it to any
major shocks.
• Do not operate the product outside the power limits
given in the specifications.
• Do not open the device or continue to operate it if it
becomes damaged.
• Dispose of packaging material immediately according
to locally applicable regulations.
• Since the battery is integrated and cannot be removed,
you will need to dispose of the product as a whole. Do
this in compliance with the legal requirements.
• Do not modify the product in any way. Doing so voids
the warranty.
4. Operation
4.1 Charging the Power Pack
• Connect the microUSB charging/connecting cable
included to the one of the two USB ports on the Power
Pack (
IN 5V/500mA
) and to the microUSB port on
your terminal device (mobile phone, smartphone, etc.).
• Alternatively, you can charge the Power Pack using
a suitable USB charger. Please refer to the operating
instructions for the USB charger used.
• Charging begins and ends automatically.
• Charge the Power Pack fully before using it for the
first time.
Note – Capacity
• The capacity is always shown when the Power Pack
is charging.
• Each status LED corresponds to 25% of the capacity.
When an LED is permanently illuminated, this
indicates that this capacity level has already been
reached. The Power Pack is charged to at least 75% if
three LEDs are illuminated, and the fourth is flashing.
• If all four status LEDs light up, the full capacity is
available.
• Press the button
of the Power Pack to switch it
on and to check its current capacity.
• To switch the Power Pack off, press and hold the
button
until the status LEDs go out.
Warnung – Battery
• Only use suitable charging devices or USB connections
for charging.
• As a rule, do not charge devices or USB connections that
are defective and do not try to repair them yourself.
• Do not overcharge the product or allow the battery to
completely discharge.
• Avoid storing, charging or using batteries in extreme
temperatures.
• When stored over a long period of time, batteries should
be charged regularly (at least every three months).
