6
Warning – Batteries
•
Do not mount the product above locations where persons might
linger.
•
We recommend installing the measuring station securely on an
outdoor wall.
•
Install an anchor, screw, nail, etc. in the wall of your choice.
•
Hang the measuring station using the opening intended for this
purpose (2).
6. Operation
6.1. Connection to the measuring station
•
To connect the base station and the measuring station, place the two
devices as close together as possible.
•
After you insert the batteries, the base station automatically searches
for a connection to the measuring station and performs initial setup.
•
If the device does not connect automatically, the manual search
program on the base station must be started.
Note
•
Initial setup takes approximately 2 minutes.
•
During the connection attempt, the radio symbol on the base
station will flash.
•
Do not press any buttons during setup. Otherwise, values may
not be transmitted correctly and there is a risk of value errors and
inaccuracies.
•
The setup process is completed when the indoor and outdoor
measurement data is displayed on the base station.
•
The measured value is automatically updated by the base device
about every 45 seconds.
•
If the temperature is outside of the measuring range, --.- (lower
than minimum temperature) or --.- (higher than maximum
temperature) will appear on the temperature display.
