3
5.2 Connect:
Connect the supplied power supply unit to the desk lamp.
Place the lamp on a stable, even, horizontal surface and adjust
to your liking. Connect the power supply unit to an easily
accessible outlet.
5.3 Settings
Light modes:
Reading mode (4300K – 5300K):
•
Makes reading easier
•
Reduces eye strain while reading
•
Well-suited for office work
Work mode (6000K – 7000K):
•
Helps maintain concentration and attention
•
Increases ability to concentrate
•
Positive lighting effects for design and research work
Relax mode (2500K – 3300K):
•
Creates a sense of security
•
Reduces stress and physical tension
•
Excellent for music, art and creative work
Sleep mode (2500 – 3300K):
•
Creates a feeling of comfort and relaxation
•
Reduces stress using soft light
•
Very well-suited for preparing for bed
Dimmer function
Using the two arrow buttons on the touch display switches on
the dimmer function. The lamp has 5 dimness levels.
Automatic switch-off function (timer):
Automatic shutoff after 60 minutes.
USB charging function
Connect a suitable USB terminal device (e.g. smartphone, MP3
player) to the USB port. Before connecting a terminal device,
check whether the lamp’s power output can supply sufficient
power for the device.
Note
The USB port cannot charge the desk lamp.
5.4 FM radio
Up to 20 stations can be saved. Press the FM button to switch
the radio on. You do not need to switch on the desk lamp
first. The frequency range is between 87.5 MHz and 108 MHz.
Using the < / > buttons, you can manually search for stations
in 100 kHz increments.
Station search
Press either < / > button for two seconds. This starts the
automatic station search and the FM button will flash. The
stations found are saved automatically. The preset button is
constantly illuminated and the first station will be played.
Delete stations
Select the appropriate station. The PRESET button must be
illuminated. Press the PRESET button for at least two seconds.
The FM button will flash once and the station will be erased
from the memory. The PRESET button will go out afterwards.
Add new stations
Select the appropriate station. The PRESET button must be
OFF. Press the PRESET button for at least two seconds. The FM
button will flash once. The station was successfully saved. The
PRESET button will now light up.
Note
•
The FM button will flash twice if the station memory
(max. 20 stations) is full and you want to save another.
•
The radio will mute during an incoming call. If the
lamp is connected to a Bluetooth device during radio
operation, the radio will switch off.
5.5 Bluetooth function
Note – Pairing
•
Make sure that your Bluetooth-capable terminal device is
on and Bluetooth is activated.
•
Make sure that your Bluetooth-capable terminal device is
visible for other Bluetooth devices.
•
For more information, please refer to the operating
instructions of your terminal device.
Bluetooth pairing:
The desk lamp and terminal device should be no further than
1 metre apart. The shorter the distance, the better. The lamp
must be switched on to search. Hold the Bluetooth button for
about 3 seconds. The telephone and Bluetooth buttons will
flash in intervals of two for two minutes. The lamp is searching
for a Bluetooth connection. Open the Bluetooth settings on
your terminal device and wait until “DL-60BSH” appears in the
list of Bluetooth devices found. Select “DL-60BSH” and wait
until the lamp is shown as connected in the Bluetooth settings
on your terminal device. If the pairing was successful, the
Bluetooth button will be constantly illuminated. The display
will go out if pairing takes longer than 2 seconds. If this
happens, you will need to switch the lamp off and on again if
you want to pair it with your terminal device again. You can
now use the Bluetooth function.
