4
Warning
Do not use the headset while it is charging.
•
If the battery is fully charged, the
status LED
(3) will go out.
•
Disconnect all cable and mains connections after use.
Note
If you have not used the item for a few month, it may take 15-30
minutes for the
status LED
(3) to red when charging.
5.Operation
Switching the headset on/off
•
Turn On:
With the device off, press and hold the
multi-function key
(1) for
3 seconds until you hear a short tone. The
LED indicator
(3) lights
up blue and a voice says, ‘Power On’.
•
Turn Off:
With the device on, press and hold the
multi-function key
(1) for
5 seconds until you hear a long tone. The
LED indicator
(3) briefly
lights up red and a voice says, ‘Power Off’.
The first time the device is turned on, pairing is automatically started
– see
5.1
Bluetooth
®
pairing.
5.1. Bluetooth
®
pairing
Note – Pairing
•
Make sure that your
Bluetooth
®
-capable terminal device is on
and
Bluetooth
®
is activated.
•
For more information, please refer to the operating instructions
of your terminal device.
•
The headset and the terminal device should not be any further than
1 metre away from each other. The smaller the distance, the better.
•
Ensure the headset is off.
•
Device off:
Press and hold the
multifunction button
(1) for
approximately 5 seconds until the
status LED
(3) begins to
alternate between red and blue and you hear a voice say, ‘Pairing’.
The headset is searching for a
Bluetooth
®
connection.
Summary of Contents for 137495
Page 2: ...B A C 1 5 6 4 3 2 ...
