Hama CC 514S, Operating Instruction

5

g

Operating Instruction

PAPER BLOCKAGE AND OVERLOAD PROTECTION:

The CC 514L has a motor with an overload protection 

function. The normal operating cycle for uninterrupted 

shredding activity is three minutes continuous operation 

followed by approx. twenty minutes switched off. The 

shredder may switch itself off automatically in the 

following cases:

1.  If the shredder is used for more than three minutes at  

  a time.

2.  If it becomes overloaded due to more than fi ve  

  sheets of paper being fed into the shredder at a time, 

  or if the paper is not fed into the shredder evenly.

3.  For your own safety, if the paper basket is removed  

  while the shredder is running.

The fi rst two cases can trigger the automatic overload 

protection function which interrupts the power supply. 

If this is the case, proceed as follows:

1.  Remove the plug from the socket and wait at least  

  twenty minutes until the overload protection function  

  resets. Remove all remaining paper from the shred 

  der or cut it off appropriately.

2.  Then connect the machine to the mains again and  

  set the switch to 

REV

. Using the reverse function, pull  

  the paper trapped in the cutting rollers out of the top  

  of the shredder. You can then set the switch back to  

AUTO

.

3.  If the switch is set to 

„AUTO”

 and the paper feeder is  

  clear, the shredder is now ready to use again.

SPECIFICATIONS:

-   Slitting size: 4 x 35 mm (cross-cut)

-   Slitting capacity: 5 sheets

-   Slitting speed: 3 m/min.

-   Max. feed width: 220 mm

-   Mains supply: 220-240 V~

-   Dimensions of the CC 514S: 340x445x120 mm