Hama EasyLine MBH-300 Operating Instructions Manual Download

Page: 7 / 10

Accept Waiting
Hold Active

Long

Add Held To TWC

Long

Volume Up

Short

Volume Down

Short

Transfer audio

Long

Toggle Mute

Long

2. Charging the battery:

Your headset has a built-in Lithium-Ion battery which must be fully
charged before you use the headset fi rst time. For the charging fi rst
time, you need to charge it for 3 hours. During the charging, the
indicator shows a steady red light. When the battery is fully charged,
the red light will turn off. For later on charging, it will take 60 minutes to
fully charge the battery or you found the red light has turned off.
You can charge the headset either by using the AC charger (travel
charger), the USB charger (USB charging cable) or the car charger
depending upon the package accessories available. Please check
your package for details.

2.1. If your package has a USB charger included:

Plug the charge lead of USB charger into the charging port of your
Bluetooth headset. And then, plug the other end of the USB charger
into the PC/Mac‘s USB port. When charging is complete (Red indicator

turns off), remove the USB charger and remove the charge lead from
your headset. (Please refer to Fig.1, Fig 2)

2.2. If your package has a car charger included:

Plug the car charger into the cigarette lighter socket. And then, plug
the charge lead into the charging port on the Bluetooth headset. When
charging is complete (Red indicator turns off), remove the car charger
and remove the charge lead from the Bluetooth headset. (Please refer
to Fig.1, Fig3)

2.3. If your package has a travel charger included:

Plug the travel charger into a 100~240V wall socket. And then, plug
the charge lead into the charging port on the Bluetooth headset for
charging. When charging is complete (Red indicator turns off), remove
the travel charger and remove the charge lead from the Bluetooth
headset. (Please refer to Fig.1, Fig 4)

3. Turning the headset on or off:

(1) Press the button for nearly 3 seconds. You will hear two beep

sounds and the blue indicator will begin to fl ash. The headset is

now powered on.

(2) When the power is on, press the button for 5 seconds. You

will hear two beep sounds and the red indicator will fl ash. Now the

headset is turned off. (Please refer to Fig.5 and Fig.6.)

Fig. 1

Fig. 2

Fig. 3

Fig. 4

charging