6
7
2.2 Inserting batteries
a) Remove the battery compartment cover and insert the batteries into the
battery compartment, observing correct polarity. The correct polarity is indi
cated there.
b) Replace the battery compartment cover so that it is securely closed.
c) Set the ON-OFF switch on the bottom of the mouse to „ON“.
2.3 Connecting the USB receiver
a) Connect the USB receiver to a free USB port on the PC.
b) Windows detects the USB receiver and installs it in the operating system.
c) The mouse normally connects to the receiver automatically and is ready for
use immediately. If this does not happen, proceed as described in section 2.4.
2.4 Connecting the mouse and receiver/Getting started
a) Press the Connect button on the receiver; the status LED starts to fl ash.
The receiver is now ready to synchronise with the mouse.
b) Using a pointed object (such as a pen), press the Connect button on the
bottom of the mouse within 10 seconds. Please note that the mouse should be
no more than a maximum of 30 cm away from the receiver during this
connection phase.
c) The status LED on the receiver stops fl ashing after the synchronisation
process has been completed successfully. The mouse is now ready for use.
If the cursor does not move, repeat steps 3a-b. You will also need to do this
if interference originating from other wireless mice or keyboards occurs
during operation.
3. Battery Indicator Display
The control light starts to fl ash when the battery voltage is too low. Although
the mouse will still function for some time, you should change the batteries as
soon as possible.
4. Power Saving Mode
If the mouse is not used for 8 minutes, it switches to power saving mode. The
optical sensor is switched off to minimise the power consumption. Move the
mouse or press any button to activate the mouse.
5. Functionality Problems
If the mouse does not function as expected, ensure that you have carefully carried
out the following steps:
• The batteries are new and have been inserted correctly
• The receiver is connected to the computer properly
• The receiver and devices are within their communication range
(depending on local conditions, max. 1.5 m)
Fig.3
Connect button
Connect button
On/off switch
00052450bda.indd Abs1:6-Abs1:7
00052450bda.indd Abs1:6-Abs1:7
12.12.2007 13:17:25 Uhr
12.12.2007 13:17:25 Uhr
