13
Professional M12CD
g
6. Troubleshooting
Error
Possible cause
Solution
The cutting rollers do
not turn on briefly after
the power button (3) is
pressed
The On/Off switch (3) on
the back is set to “0”.
Switch the on/off switch
(8) to position
1
.
The connection cable
(2) is not connected
correctly.
Ensure that the mains
plug is plugged into the
socket.
No mains power
Check your fuse box.
Device is faulty.
Inform our customer
service department.
The overload warning
LED (13) lights up in red
Too much paper has
been inserted or it has
been drawn in croo-
kedly.
Switch the device off
and let it cool off for at
least 30 minutes. Then
complete the steps un-
der 4.2.4. “Forward and
reverse modes”
The overheating war-
ning LED (14) lights up
in red
The device is overhe-
ated
Switch the device off
and let it cool off for at
least 30 minutes.
The Bin full LED (15)
lights up in red
The bin (9) is full.
Empty the bin.
Summary of Contents for PROFESSIONAL M12CD
