Chapter 4. EQ-77X Setup
EQ-77X LDLS® Operation Manual
18
of
31
4.1.4 Optical Interface
for dimensional drawings of the lamp.
4.1.5 Signal Connections
The
EQ-77X
is controlled through the remote I/O connector.
10.2 I/O Connector Pin Assignment
gives the pin assignments and functions for this interface. Connect to the user’s
control system using a suitable cable. Mating connector is a standard high-density 15-pin d-sub male (for example,
Amp part no. 748364-1 with contacts 1658670-2).
Optionally, connect a model EQ-99-RC remote control module to the I/O connector using the supplied cable. The
EQ-99-RC is shipped with an interlock jumper plug installed. To use the remote interlock function, connect a remote
contact or solid-state switch across pins 1 and 3. Mating connector is a standard 3-pin mini-DIN, CUI Inc. part no.
MD-30 or equivalent. See the figure
EQ-99-RC Remote Control Rear Panel
below for pin connections.
Fluid Fittings
Figure 4.
