Chapter 3. Preparation of System
EQ-77X LDLS® Operation Manual
12
of
31
Chapter 3. Preparation of System
3.1 Unpacking Guide
Start by inspecting all parts of the system for completeness and any damage incurred in shipping. The EQ-77X shipping
box should contain:
Required
Optional
If any part is missing or appears damaged, contact Energetiq
immediately. Do not attempt to substitute any parts.
There are no user-serviceable parts inside the
EQ-77X
lamp head or power supply controller unit.
3.2 System Description
The
EQ-77X system consists of a power supply controller, lamp head, controller-to-lamp-head interconnect cable (not
shown), and power input cable (not shown). I/O interface connections (also not shown) are provided by the user.
The following sections provide descriptions of the system components and controls, and give an overview of their
functions. Refer to
for more detailed information.
•
EQ-77X
power supply controller unit
•
EQ-77X
lamp head unit
• Black interconnecting cable from lamp head to power supply controller (21-pin mixed D-sub)
•
EQ-99-RC remote control module with interlock connector
•
I/O cable with 15 pin D- connector at each end
EQ-77X
Controller
Figure 2.
