13
Adjustments
The L-702 laser has Pitch and Yaw angular adjustments with coarse and fine resolutions.
The beam is emitted from the large hole in the center of the spindle or from the side of
the turret in the L-702SP version.
Warning -
Do not stare into the beam.
Pitch/Yaw Adjustment
The adjustment knobs are used to adjust the
pitch
and
yaw
angles of the laser when used
in a spindle and the
pitch
and
roll
angles when used for flatness. They use
differential
micrometers. This means the micrometers have a coarse and fine function.
•
Coarse Adjustment
– tighten the set screw to disable the fine adjustment.
•
Fine Adjustment
– loosen the set screw with the provided Allen wrench to
enable the fine adjustment, which is 12-times finer adjustment resolution.
Hardware Requirements
To qualify the L-702 to the spindle’s AOR you will also need the L-702 Laser, T-
261 Four-Axis Target, the R-358 Computer Interface and Lathe9 or Spindle8.
If using the manual procedure, then you will need two R-1307 readouts, one for the
c
enter
readings and one for the
angular
readings.
(See Appendix B beginning on
Page 27
Figure 13– L-702/L-702SP Pitch and
Roll Adjustments
Figure 14—Differential Micrometer
Summary of Contents for L-702
Page 1: ......
Page 7: ...4 L 702 L 702SP Laser Dimensions...
