19
Switching L-702SP Turret to Scan Mode
To create the L-702SP perpendicular
laser scan plane a flip mechanism is used
to move a pentaprism into the laser beam
that bends the beam 90 degrees. This
creates a perpendicular laser beam that
emits from the side of the spindle, which
is then rotated to create the scanning
laser plane. The flip mechanism is
controlled by a screw in the top of the
spindle. Use a standard screwdriver to
turn the screw until you feel a “click”,
which is a small magnet that holds the
prism in place. You can confirm that the
mechanism is properly in place by noting
if the laser beam emits from the hole in
the side of the turret.
Summary of Contents for L-702
Page 1: ......
Page 7: ...4 L 702 L 702SP Laser Dimensions...
