1
R-1308 Auxiliary Target Readout - Overview
The R-1308 Auxiliary Target Readout is an accessory for the A-1519 and A-1520 Type II Unitargets.
This single-axis, lightweight readout attaches directly to the post of the magnetic target base and
connects to the auxiliary port on the side of the target, providing an excellent backup for the R-1310-900.
Note:
This unit operates with Unitarget firmware version 8.021 or later. Units shipped prior to July 15,
2007 may require a firmware upgrade, available from Hamar Laser Instruments.
Target Features
•
Bright LED display with up to 4 decimal places of resolution for easy target readings.
•
No batteries, external power supply or charger is required. The unit is powered directly by a
connection to the Unitarget and draws a minimal amount of power directly from the Unitarget
battery. At the normal brightness setting, the target display draws less than 100 mW.
•
User-selectable display allows the target position to be viewed in either inches or millimeters and in
Relative (Zero) or Absolute modes.
The picture at the right shows a Unitarget mounted on a
standard 5/8 in. (15.75 mm) diameter post, with the R-
1308 mounted directly beneath the target. The numerical
indicators are as follows:
(1)
Locking nut
(2)
Unitarget Auxiliary Por
t (supplies power to the
R-1308 Target)
(3)
Display Units
(4)
Display Resolution
(5)
Zero Mode
(Relative/Absolute)
(6)
Display Mode
(reserved for future use)
Mounting the R-1308
1.
Shut off power to the Unitarget.
2.
Slide the R-1308 mount on to the target post until it
is 1 in. (25 mm) or less below the base of the target.
The R-1308 can be mounted perpendicular to the
target post, as shown, or parallel to the target post for
vertical pane applications.
3.
Tighten the locking nut.
4.
Connect the R-1308 cable to the Unitarget Auxiliary
Port.
Do not force the connection.
The arrow on the
plug should face toward the back of the target.
Summary of Contents for R-1308
Page 1: ......
