2
Using the R-1308
1.
Turn on power to the Unitarget. The R-1308 displays
while it initializes.
Do not proceed
until a numerical reading displays.
2.
Set the Display Units by pressing the DISPLAY UNITS button to toggle between inches and
millimeters. The corresponding LED on the front panel lights.
3.
Set the Display Resolution (the desired number of decimal places) by pressing the DISPLAY RES
button.
Note:
The DISPLAY MODE button is not used in the standard model and is reserved for special
applications.
Zeroing the Display
1.
To enable Relative position, press and hold the ABS/REL button until the display reads zero. Release
the button. The last position reading is memorized as an offset that is subtracted from all subsequent
position readings. The REL LED lights when the display shows a reading with no offset applied.
2.
Press the ABS/REL button quickly to toggle between Relative and Absolute modes.
Note:
The best way to zero the display without disturbing the position measurement is to place your
index finger directly behind the ABS/REL button and then push the button with your thumb, as if you
are pinching the right side of the unit.
Summary of Contents for R-1308
Page 1: ......
