12
AudioAce
™
Portable Bluetooth
®
CD Player
Listening to CDs
Insert a CD:
1. Open the CD door by pressing the Open button.
2. Insert a disc into the disc compartment with the title side up.
3. Close the CD compartment door.
Removing a CD:
Press the
Stop/M+
button once, open the CD door by pressing
Open
button. Remove the CD when it has stopped spinning.
Playing a CD:
1. Press the
Source
button to select CD mode.
2. Insert CD into player, “
---
” will appear for a few seconds, and the total
track/ file number will appear on the display and the CD will
automatically start playing.
3. Pres
/Tune+
or
/Tune-
button to jump to next/previous
track playing.
4. Press and hold the
/Tune+
or
/Tune-
button to fast forward/
rewind the track playing.
5. Press the
Play/Pause/Pair
button to pause the CD playing. Press
again to resume play.
6. Press the
Stop/M+
button to stop the CD playing.
7. After all tracks have been played, the CD player will stop automatically.
Programming CD Tracks:
You can preset up to 20 program tracks for easy access. “
FU
” will appear
on the LCD display when 20 tracks have been programmed.
1. Make sure the CD is not running by pressing the
Stop/M+
button.
2. Press the
MEM/PROG
button once, and “P01” will blink on the LCD
display, then “
00
” will appear on the LCD display.
3. Press the
/Tune+
or
/Tune-
button until the display shows the
desired track number.
4. Press the
MEM/PROG
button to store the selection
5. Repeat steps 3-4 to store additional tracks.
6. Once the last desired track is programmed, press the
MEM/PROG
button to complete the programming process.
7. To play the stored sequence, press the
Play/Pause/Pair
button.
8. To cancel program, press the
Stop/M+
button twice.
9. After all memory tracks have been played, the player will stop
automatically.
