8
How to Use Reversible Shredding Disc
w
WARNING
Laceration Hazard.
• Handle disc carefully; it is very sharp. Make sure unit is switched to OFF ( ) and is unplugged.
• Always use food pusher to feed food into the chute. Never push food through chute with hands or
other objects.
1.
Place Bowl on Base with handle facing the front. Disc is labeled FINE SHRED on one side and
COARSE SHRED on the other side. Carefully place Shredding Disc straight down onto Motor Shaft
with desired side facing UP.
2.
Place Lid on Bowl. Raise Locking Arm up and over Bowl and snap into place. Plug into outlet.
3.
Place food into Food Chute and press Food Pusher Grip securely into food by pushing down on the
Food Pusher. Do not fill Bowl above MAX Fill Line.
4.
Select LO speed by turning the Speed Dial to the left. NOTE: Food Processor will start in the speed it
was last used.
5.
Press the ON/OFF (I/ ) Switch up to turn ON (I) Food Processor. Press Switch down to turn OFF ( ).
6.
When finished, switch to OFF ( ).Unplug. Push Locking Arm back to unlock Lid and lower Locking Arm.
7.
Always remove Lid before removing Bowl to avoid possible damage to the appliance.
NOTES:
• Check to make sure no other blades are in the bottom of the Bowl.
• LO speed is recommended for slicing and shredding.
• For smaller, thinner foods, like carrots, cut in half and load pieces side by side in the Food Chute in an upright position
to prevent the food from falling over. This will produce more uniform results.
Summary of Contents for Stack & Snap 70815
Page 17: ...17 Notes...
