6
How to Brew a Single-Serve Pod
w
WARNING
Burn Hazard.
• Do not lift lid during the brewing process.
• Fully insert cup or travel mug on drip tray.
• If overflow occurs, unplug and allow coffee maker to cool.
w
CAUTION
Cut Hazard.
Removable single-serve pod holder has a sharp needle. Piercing
needle on underside of lid is also sharp. Use caution when handling.
NOTES:
• If FlexBrew Lid is opened or any button was pressed to end brew
cycle early, discard contents of cup or travel mug and pod. Press
desired cup size button to restart brewing cycle.
• Use only cold water in Removable Water Reservoir. Do not use hot
water.
• Do not reheat coffee in machine.
• Do not use creamer or nondairy creamer in Reservoir.
• After brewing hot cocoa single-serve pods, brew a water-only cycle
without a single-serve pod to avoid possibility of clogging Piercing
Needle.
• Press any cup size to stop brew cycle.
• Do not brew coffee before ensuring Removable Needle Holder
arrow icon ( ) is aligned with lock icon ( ) inside FlexBrew Lid.
1. Fill Removable Water Reservoir with water up to
56 oz. (1656 mL). Do not exceed MAX fill line.
2. Place a cup on Cup Rest with Drip Tray. If using
a travel mug, remove Cup Rest with Drip Tray.
3. Plug into outlet.
4. Press Power Switch, located on right side panel,
to ON (I) position. NOTE: While preheating,
lighted buttons will slowly fade in and out.
When lights stay on, Coffee Maker is ready to
brew.
5. Lift FlexBrew Lid.
6. Place Gray Removable Single-Serve Pod
Holder in Funnel.
7. Place a pod into Single-Serve Pod Holder. Do
not remove foil.
8. Close FlexBrew Lid until fully latched.
9. Press desired cup size button: 8 oz. ( ) or 10
oz. ( ). NOTE: After one minute without a
button press or Lid opening, unit will go into
standby mode, and all lights will turn off. To
wake unit, press any button, and all lights will
illuminate. Then make desired brew selections.
For a stronger cup of coffee, press BOLD
( ) Button before selecting desired cup size
button.
10. Desired cup size button will illuminate when
coffee is brewing.
11. When coffee stops brewing, all lights will
illuminate for one minute.
12. Open FlexBrew Lid and discard used pod.
Single-Serve Pod Holder should be rinsed after
every use.
13. Press Power Switch to OFF ( ) position or unit
will stay preheated for 30 minutes.
14. Unplug.
