w
WARNING
Electrical Shock Hazard
Disconnect power before cleaning.
Failure to do so can result in death
or electrical shock.
6
Cleaning the Container Guide,
Container Rest, and Housing
Cleaning and Sanitizing the Container, Spindle, and Agitator
1.
Unplug mixer.
2.
Remove the container guide (see page 5).
3.
Wash the container guide with hot, soapy water;
then rinse.
4.
Clean the housing, front panel, and container
rest with a damp, soapy cloth.
5.
Wipe dry with a clean, soft cloth.
6.
Reinstall the container guide.
NOTE:
Do not spray or submerge the mixer.
Any resulting water damage will not be covered
by the warranty.
7.
Plug mixer into a grounded outlet.
Cleaning
1.
Place a drop of detergent and 1 cup of water into
the mixing container.
2.
Position the container into the container guide and
mix on low speed (I) for 5 seconds. Empty the
container.
3.
Place 1 cup of clean water into the container and
repeat mix for 5 seconds to rinse.
NOTE:
Inspect agitators daily. Replace agitators
every 90 days.
Sanitizing
For best results, use the Hamilton Beach Universal
Container (#110E).
1.
Fill the container with sanitizing solution
(1 tablespoon of household bleach per
1 gallon of water at 50-70°F) to
3
⁄
4
full.
Position the container properly on Mixer
and run on low speed (I) for 1 minute.
2.
Remove container. Empty sanitizing solution and
rinse container.
3.
To dry, run the mixer on low speed (I) for 30
seconds with empty container in place.
DO NOT
RINSE
after sanitizing is completed.
NOTE:
If preferred, the container guide, container,
and agitator may be cleaned in a dishwasher.
Care and Cleaning of the Mixer
Cleaning the Container Guide, Container Rest, and Housing
