Page 33 of 92
520008300 08/14
SmartServe™ Drink Mixers Service Manual
Removal and Replacement
Interface Display Board
The interface display board is located on the operator interface panel and is used to display
information to the user and relay input commands to the control board assembly.
To remove the interface display board:
1. Remove the operator interface panel assembly (1) as outlined in this manual.
2. Disconnect the touch pad ribbon cable (2) from the display board (3).
3. Remove eight screws (4) and gently pull upper boards from lower board.
CAUTION
Use care when removing the upper boards from the lower board to avoid damage to
the pins.
4. Remove three screws (5) and lower board from panel.
5
4
4
2
1
3
To install the interface display board:
1. Separate the display board assembly.
2. Install the lower board with three screws (5) to the operator interface panel
assembly (1).
CAUTION
Use care when installing the upper boards on the lower board to avoid damage to the
pins.
3. Gently place the upper boards on the lower board. Ensure the pins line up.
4. Install eight screws (4).
5. Connect the touch pad ribbon cable (2) to the display board (3).
6. Install the operator interface panel assembly (1) as outlined in this manual and verify
operation.