Page 65 of 92
520008300 08/14
SmartServe™ Drink Mixers Service Manual
Removal and Replacement
Wash Chamber Assembly
The wash chamber assembly is located under the wash chamber cover.
To remove the wash chamber assembly:
1. Shut off water supply, disconnect water line from machine, and purge the system to
remove water from the lines.
2. Remove the safety shield assembly as outlined in this manual.
3. Remove the top cover as outlined in this manual.
4. Remove three screws (1) from each side of the machine.
5. Lift the front panel wrap (2) from the machine.
NOTE:
Avoid overextending the wire harness attached to the interface panel on the wrap.
NOTE:
Cover front panel wrap to avoid scratches/damage from contact with side of machine.
6. Using a large wire tie (3), secure the wrap (2) to the machine using the hole in the top of
the side panel (4).
4
3
2
2
1
7. Remove the cup shield (5) by pressing the tab (6) in the cup guard and shield
assembly (7) and turn the cup shield (5) clockwise.
6
5
7