Document #101-0163
7
1/10/06
Unpacking
There are a number of points to keep in mind while unpacking your Hamilton Token Vendor. These items will
make the installation and continued operation of your machine run smoother. These tips are listed below.
Be sure to save your key
The key is placed inside a small cloth bag and attached to the outside of the machine. When removing the
shrink-wrap, be sure to locate the bag containing the key and set it aside so it does not get thrown away.
NOTE: MAKE A PERMANENT RECORD OF THE NUMBER ON YOUR KEY IN CASE KEY IS
LOST AND MUST BE REORDERED
.
Remove the packing strap from the hopper
The hopper comes shipped with a packing strap secured around it to minimize the vibrations caused by
shipping. If this strap is not removed, the hopper will not tip out for easy filling. The strap may be cut off with
a pair of wire cutters or sturdy scissors. Cardboard is placed around the edges of the hopper to protect it
during shipping. If strapping will not pull out from beneath hopper plate then loosen the 3 #1/4 nuts holding
plate and try again. Once strapping is out, tighten the 3 #1/4 nuts. Then be sure to remove the cardboard as
well.
Remove all packing debris from hopper
During unpacking, ensure that debris does not fall into hopper bowl. If this material is not removed, the hopper
could jam. With the power completely disconnected, remove all loose material inside the hopper bowl.
