TROUBLESHOOTING
If T5 Fluorescent bulb(s) does not come on:
If all lamps do not light with 10 seconds turn off the system. Re-examine all connections between the bulbs and the end caps.
Examine lamp for possible damages to the pins.
Exchange lamp with a known working lamp.
All lamps must be installed for system to operate properly.
Switch lamps from socket to socket.
Check your electrical source. Make sure the ballast is plugged into power properly.
If both of the Fluorescent bulbs are not working after you re-examine everything it is likely to be a ballast problem. Contact manufacture.
If T5 Fluorescent bulb(s) come ON and OFF:
Unplug the system and check for a bad contact between the lamps and the socket.
My circuit breaker or power strip trips every time I turn on the ballast
:
The circuit might be overloaded. A standard house circuit is 15 amps: calculate the amount of amperage going into the circuit.
Metal Halide ballast takes up to 6 amps each and T5 or Power Compact ballasts take up to 1.82 amps.
Verify that you do not have too many items going into the same circuit.
HAMILTON TECHNOLOGY LIMITED WARRANTY
LIMITATION OF IMPLIED WARRANTIES AND EXCLUSION OF CERTAIN DAMAGES:
The company disclaims liability for incidental and consequential damages for breach of any express or implied warranty, including any implied warranty of
merchantability, with respect to this product. This writing constitutes the entire agreement of the parties with respect to the subject matter hereof. No
waiver or amendment shall be valid unless in writing signed by the company.
WHAT THE WARRANTY COVERS:
Hamilton Technology warrants this product to the original purchaser against defective material and workmanship that occurs during normal use for 12
months from the date of the original purchase
. Hamilton will, at Hamilton’s option, either repair or replace same without charge
.
EXCLUSIONS:
1. Damage resulting from accident, misuse, abuse, lack of reasonable care, subjecting the product
to any but the specified electrical service, other than normal and ordinary use of the product,
subjecting the product to any abnormal working conditions or any other failure not resulting from
defects in materials or workmanship.
2.
The manufacture shall not be liable for any damaged to products not in their original packaging.
3. Damage resulting from modification, tampering with or attempted repair by anyone other than the
company.
4. Transfer of product to someone other than the original consumer purchaser.
5
