Document #101-0038
7
11/08/06
II. MAINTENANCE
CHANGING "PAY HERE" LEXAN®
1.
Unlock, open door and turn off power to the Autocashier.
2.
Turn off main breaker for Autocashier
3.
Remove the 2 #10-24x3/8 screws from the underside of the Light Bracket.
4.
Slide the Top Piece away from the front of the hood.
5.
Remove Top Piece completely.
6.
Remove rubber gasket seal from top lip of Light Bracket.
7.
Remove both fluorescent lamps, by turning them clockwise till they unlock and slide forward.
(Towards Lexan®)
8.
Remove the Lexan® rail clamp by removing the 4 #8-32x5/16 nuts.
9.
To remove the "Pay Here" Lexan® you want to push the top portion of the Lexan® away from the
front of the Light Bracket and pull up.
Note: The "Pay Here" Lexan® is siliconed on all four sides, so you may have to use a sharp knife to
break the seal of the silicone to remove the Lexan®
10.
Once the Lexan® is removed you will want to remove all of the extra silicone before attemping to
put the new Lexan® in.
Note: It is recommended that if you change the Lexan® that once you have replaced it you should
resilicone the Lexan® back in to prevent any damage to your equipment.
11.
Once the Lexan® is replaced, reinstall the Lexan® rail clamp using the 4 #8-32x5/16 nuts.
12.
Reinstall the fluorescent lamps by sliding them into sockets and turning counter clockwise 1/2 turn till
they lock.
13.
Reinstall the rubber gasket seal on the top lip of the Light Bracket.
14.
Reinstall the Top Piece by sliding it towards the front to the Light Bracket.
15.
Reinstall the 2 #10-24x3/8 screws to the underside of the Light Bracket.
16.
Restore power to your machine.
Use only LEXAN brand, 1/8 “ thick plastic sheeting with the following dimensions:
FRONT: 21-15/16 “ x 4-1/4” x 1/8"
