Document #101-0038
8
11/08/06
CHANGING THE BOTTOM LEXAN®
1.
Unlock, open door and turn off power to the Autocashier.
2.
Turn off main breaker for Autocashier
3.
Remove the 2 #10-24x3/8 screws from the underside of the Light Bracket.
4.
Slide the Top Piece away from the front of the hood.
5.
Remove Top Piece completely.
6.
To remove the Bottom Lexan®piece you want to push the Lexan® to one side. It can be removed
from either the right side or left.
Note: The Bottom Lexan®piece is siliconed on both ends, so you may have to use a sharp knife to
break the seal of the silicone to remove the Lexan®
6.
Once the Lexan® is removed you will want to remove all of the extra silicone before attemping to
put the new Lexan® in.
Note: It is recommended that if you change the Lexan® that once you have replaced it you should
resilicone the Lexan® back in to prevent any damage to your equipment.
7.
Reinstall the Top Piece by sliding it towards the front to the Light Bracket.
8.
Reinstall the 2 #10-24x3/8 screws to the underside of the Light Bracket.
9.
Restore power to your machine.
Use only LEXAN brand, 1/8 “ thick plastic sheeting with the following dimensions:
BOTTOM: 21-15/16" x 3-3/8" x 1/8"
