HTK
INSTALLATION MANUAL
6
Mechanical Installation
Mechanical Installation
Receiving and Unpacking HTK
When HTK is shipped, it is bolted to a pallet/skid with a cardboard box surrounding it for protection. This
pallet contains the pay station only - bases (if ordered) will be in separate cardboard boxes.
Remove the cap screws that are securing the cardboard box to the pallet and slide the box off HTK.
Remove the two cardboard pads that are taped to the face (screen-side) of the HTK. Within these pads are
the lock inserts, keys, and ‘T’ handle that is used to open the HTK door - remove and set aside. Remove the
shrink wrap and the clear bag covering HTK.
Save your keys
MAKE A PERMANENT RECORD OF THE NUMBERS ON THESE KEYS (see page 5).
Open the HTK door
Use the ‘T’ handle to open the HTK door by inserting it into each lock cylinder and turning counter-clockwise.
Remove the packing strap from the hoppers
Each hopper is shipped with a packing strap secured to it to minimize vibrations in transit. Cut the straps
using wire cutters or sharp scissors.
Remove the receipt paper
A roll of receipt paper is stored in one of the hoppers. Remove this for installation later.
Remove all packing debris from the hoppers
During unpacking, ensure that debris does not fall into the hopper bowls. If this material is not removed,
the hoppers could jam. With the power disconnected, remove any loose material inside the hopper bowls.
Removal of additional packing materials
Remove the following to ensure proper operation:
• Strapping around XE validator (if optioned)
• Tape around Cashflow validator (if optioned)
• Tape around the coin mechanism
• Tape from the coin/token box
• Tape and paper on the front of the bill dispenser (if optioned)
Figure 1.1:
HTK pallet (face)
Figure 1.2:
HTK pallet (side)
