15
INSTALLATION
FIREBOX LINER PANELS
The Hamlet Camborne Deluxe stoves use firebox
liner panels to the sides and back. The throat plate
sits on top of the sides and rear panels. These
should come fitted to your stove, if however they
are not, proceed as follows to fit them.
Open the fire door.
Remove the two round front fuel retaining
bars, by lifting one end free of the bracket
and sliding the remaining end out from the
bracket.
Set the small liner / liners into the back of
the firebox.
Insert side liner panels. (See Fig. 6)
Fit the throat plate with the single bend and
two cut outs to the front facing up. The
projecting lugs sit on top of the side liners.
The long centre tab on the back edge rests
on the rear liners. The shorter turn down
tabs against the vertical face.
(See Fig. 7 & 8)
Replace the front fuel retaining bars.
Note: Neither the rear firebox liners nor the
side firebox liners are ‘handed’, both faces are
suitable for direct contact with the fire bed.
Note : Cracking of the lining panels does not
effect efficiency.
Fig. 5. Overall View Of Liners
& Throat Plate Assembly
Fig. 6. Liners Inserted
Fig. 7. Inserting The Throat Plate
Fig. 8. Liners & Throat Plate
Correctly Fitted
Hamlet Camborne Deluxe Stoves
