7. Set up the jumper ID as “Master” mode according to the HDD jumper
setting spec or "Single Master" mode for Western Digital model hard
drive. Connect
(A)
the 40-pin IDE connector and
(B)
the power connector
from the Base Plate securely to the hard drive.
8. Align the hard drive and the Base Plate holes. Secure the Drive to Base
Plate with four 10mm diameter screws.
9. Align the rear Base Plate to the Sleeve Slot. Slide and push the hard
drive/Base Plate into the Enclosure Sleeve
13
(B)
(A)
Front Sleeve
Summary of Contents for HEXD5UA
Page 20: ...Step 3 Step 4 Step 5 20...