Wireless ADSL2
+
Router
HRDSL150W
User Manual
66
ADSL2+ Router, check the IP addresses of Wireless ADSL2+ Router and your
computer. Make sure your computer is set to get a dynamic IP address; or if you
want to use a static IP address on your computer, make sure that it is on the same
subnet as Wireless ADSL2+ Router.
4
Make sure you entered the correct password. The default password is “hamlet”.
5
If these steps fail to correct the problem, contact the distributor.
Web Configuration
I cannot access the web configuration.
STEPS
CORRECTIVE ACTION
1
Make sure you are using the correct IP address of Wireless ADSL2+ Router. Check
the IP address of Wireless ADSL2+ Router.
2
Make sure that there is not a console session running.
3
Check that you have enabled web service access. If you have configured a secured
client IP address, your computer’s IP address must match it.
4
For WAN access, you must configure remote management to allow server access
from the Wan (or all).
5
Your computer’s and Wireless ADSL2+ Router’s IP addresses must be on the same
subnet for LAN access.
6
If you changed Wireless ADSL2+ Router’s LAN IP address, then enter the new one
as the URL.
7
Remove any filters in LAN or WAN that block web service.
The web configuration does not display properly.
STEPS
CORRECTIVE ACTION
1
Make sure you are using Internet Explorer 5.0 and later versions.
2
Delete the temporary web files and log in again.
In Internet Explorer, click
Tools
,
Internet Options
and then click the
Delete
Files ...
button. When a
Delete Files
window displays, select
Delete all offline
content
and click
OK
. (Steps may vary depending on the version of your Internet
browser.)
Login Username and Password
I forgot my login username and/or password.
STEPS
CORRECTIVE ACTION
1
If you have changed the password and have now forgotten it, you will need to upload
the default configuration file. This will erase all custom configurations and restore all
of the factory defaults including the password.
2
Press the
Reset
button for five seconds, and then release it. When the
LINK
LED
begins to blink, the defaults have been restored and Wireless ADSL2+ Router
restarts.
3
The default username is “admin”. The default password is “hamlet”. The
Password
and
Username
fields are case-sensitive. Make sure that you enter the correct
password and username using the proper casing.
4
It is highly recommended to change the default username and password.
