ADSL2+ Ethernet Modem
HRDSL524
58
9.4 Login Username and Password
I forgot my login username and/or password.
STEPS CORRECTIVE
ACTION
1
If you have changed the password and have now forgotten it, you will
need to upload the default configuration file. This will erase all custom
configurations and restore all of the factory defaults including the
password.
2
Press the
Reset
button for five seconds, and then release it. When the
LINK
LED begins to blink, the defaults have been restored and ADSL2+
Ethernet Modem restarts.
3
The default username is “admin”. The default password is “hamlet”. The
Password
and
Username
fields are case-sensitive. Make sure that you
enter the correct password and username using the proper casing.
4
It is highly recommended to change the default username and password.
Make sure you store the username and password in a save place.
9.5 LAN Interface
I cannot access ADSL2+ Ethernet Modem from the LAN or ping any computer on the LAN.
STEPS CORRECTIVE
ACTION
1
Check the Ethernet LEDs on the front panel. A LAN LED should be on if
the port is connected to a computer or hub. If the LAN LEDs on the front
panel are off, refer to
Section 9.1.2
.
2
Make sure that the IP address and the subnet mask of ADSL2+ Ethernet
Modem and your computer(s) are on the same subnet.
9.6 WAN Interface
Initialization of the ADSL connection failed.
STEPS CORRECTIVE
ACTION
1
Check the cable connections between the ADSL port and the wall jack.
The DSL LEDs on the front panel of ADSL2+ Ethernet Modem should be
on.
2
Check that your VPI, VCI, type of encapsulation and type of multiplexing
settings are the same as what you collected from your telephone
company and ISP.
3
Restart ADSL2+ Ethernet Modem. If you still have problems, you may
need to verify your VPI, VCI, type of encapsulation and type of
multiplexing settings with the telephone company and ISP.
