12
Hammer Engines GmbH / IQ-Serie / Instruction Manual
Electronic Data Terminal – EDT
Instructions
All parameters relevant to this operation of the turbine will be transmitted to the EDT via the
Terminal where they are being stored. The following will give you an overview of the
complete menu structure.
You input commands by pressing the four buttons UP (
), DOWN (
), ESC (
) and Enter
(
).
You can connect the terminal to a running system in order to check and change parameters on
the fly.
Using the up and down arrows
you scroll up and down or increase and decrease values.
Using the
–button you can exit the menu without storing any changes made. Any changes
made followed by pressing ESC will NOT be stored.
You store these changes by pressing the
-button. For example, should you change the max
RPM from 100.000 to 105.000 followed by pressing ENTER you are in effect storing the new
values.
