4
5
© 2018 HAMMER. All rights reserved
Car express charger
EN
QUICK START GUIDE
Hammer car express charger
Lot number:
201812
For the sake of your safety, please read this manual carefully. This quick
start guide is intended to familiarize the user with the operation of the
device. Without prior written consent of the manufacturer, no part of this
manual may be photocopied, reproduced, translated or transmitted in any
form or by any means, electronic or mechanical, including photocopying,
recording or storing in any systems of storing and sharing information. All
other trademarks and copyrights belong to their respective owners.
The product appearance (shape and colours) may differ slightly from the
pictures presented in this manual.
Safety of use
Read these guidelines carefully. Not following them may be dangerous or
illegal. Do not switch on the device when the use of mobile phones is prohibited
or if it might cause interference or danger. The manufacturer is not liable for
damages caused by independent alterations. The same applies to the use of
wires other than the original ones. Protect the device from water and other
liquids. The device should not be used when the humidity of air is high. It can
influence work and the life span of electronic components. This device should
not be operated by people (including children) with limited physical or mental
abilities, as well as by people with no earlier experience in operation of electronic
equipment. They may use the device only under supervision of people responsible
for their safety. This device is not a toy. Keep the device out of reach of children.
Attention!
The manufacturer
is not responsible
for any consequences caused
by improper usage of the phone and not obeying the above instructions.
Manufacturer
mPTech Ltd.
Nowogrodzka 31 street
00-511 Warsaw
Poland
Manufactured in China
Technical Specification:
Model:
HAMMER CAR EXPRESS CHARGER
Input/output parameters:
12/24 V
Output parameters:
Socket 1: 5V 2,4 A
Socket 2: QC 3,6-6,5 V 3A, 6,5-9V 2A, 9-12V 1,5A
Diodes:
Blue (power supply indicator)
Material:
Plastic
Compatibility:
QC 2.0, QC 3.0, MTK PE2.0, HUAWEI FCP/SCP, SAMSUNG BC1.2,
APPLE 2,4A
Dimensions:
59 x 28 x 28 mm / 2.32” x 1.10” x 1.10”
Weight:
22g/ ca. 0.05 lb
Arrangement of components in the car charger
1. Plus elektrode (+) 2. Minus elektrode (-) 3. Housing 4. Supply diode
5. USB socket QC 3.0 6. USB socket QC 2.4 A
Operation of a car charger
Plug the charger into the cigarette lighter socket in your car.
The charger is designed to be used in the most car cigarette lighter sockets.
Connect the device or devices you wish to charge or use the cable of the charger
sockets and the device. If the device might use one of the popular quick charge modes
(QC 2.0, QC 3.0, MTK PE2.0, HUAWEI FCP/SCP, SAMSUNG BC1.2) use the red socket (5).
Do not use excessive force for it can cause damage to the device or supply socket.
When charging is complete, disconnect the device or USB cable from the charger and
disconnect the charger from the cigarette lighter socket in your car.
Disconnect an unused charger from power grid. If the charger is damaged, do not
repair it, replace it with a new charger.
Troubleshooting
In case of any problems with the device, please refer to the following tips.
Despite connection, the charger does not charge the device.
Check whether the cigarette lighter socket to which the charger is connected; is not
damaged or whether the fuse protecting the cigarette lighter socket has not burned.
If you are using an extension cord or surge protection strip, make sure that the socket
to which the charger is connected is turned on.
Check if the USB wire is not damaged. If so, use a new cable certified by the
manufacturer of the equipment.
Check if the charged device is not damaged.
The charger heats up
It is normal for the charger to heat up.
Check if the charged device does not consume too much energy.
© 2018 HAMMER. All rights reserved
Car express charger
EN
