62
min 19 mm
min 19 mm
$
"
#
%
!
3
4
1
2
!
!
Planer-Thicknesser
A3-26 / A3-31 / A3-41
Fig. 11-5: Assembling position
11.5.2 Sharpening/changing the standard planer knives
Fig. 11-4: Sharpening/changing the standard planer knives
1.
Before beginning any maintenance work on the
machine, switch it off and secure it against acciden-
tally being switched on again.
2.
Both planer tables must be tilted up and secured with
the fall locks.
3.
Remove all the blade-holder screws from one planer
knife.
4.
Remove the knife holder and planer knife.
5
. Clean resin residues thoroughly from the planer knife,
knife base and cutterblock. Use resin remover art. no.
10.0.002 (0.5l) or 10.0.023 (1l).
6.
Resharpen or replace the planer knife.
7.
Insert the planer knife and knife holder again.
First, gently tighten all the blade-holder screws.
8.
Place the adjustment device onto the cutterblock so
that the planer knife points towards the marking.
The planer knives are pushed towards the top by the
adjustment springs.
9.
Tighten all the knife holder screws (minimum torque
15 Nm).
10.
Repeat steps 3 to 9 for the other planer knives.
!
Blade-holder screws
"
Blade holder
#
Planer knife
$
Adjustment spring
%
Adjustment device
&
Marking
Attention! Risk of material damage!
Do not clean with compressed air! Ensure that the planer knife is positioned correctly!
Attention! Risk of injury!
The planer knives are razor sharp. Handle the planer knives with the utmost care. especially when turning
the cutterblock by hand.
Attention!
Execute the following instructions exactly!
Always tighten the knife holder screws from the inside to the outside.
Note: Checking the joint adjustment
It may be necessary to readjust the joint if the planer knives have been changed or replaced.
See Chapter >8.3 Adjusting the joint<
Faults
Summary of Contents for A3-26
Page 64: ...64 Planer Thicknesser A3 26 A3 31 A3 41...
Page 65: ...65 Planer Thicknesser A3 26 A3 31 A3 41...
Page 68: ......
Page 69: ......
