58
Panel Saw
K3 basic/K3 winner/K3 e-classic
Operation
Fig. 9-7: Trimming with trimming equipment
Using trimming equipment:
1.
Take note of general procedures for authorised
working techniques.
2.
Mount the trimming equipment (Assembly instructions
„Trimming equipment“).
3.
Lock the sliding table.
*)
4.
Clamp the unfinished plank, with the hollow side
facing upwards into the trimming equipment.
5.
Switch on the circular saw.
6.
Feed the trimming equipment and the workpiece
together constantly past the saw blade, keeping
fingers balled into a fist.
*)
*)
The trimming equipment is pushed along the sliding table‘s groove.
9.5.6 Cutting battens
1.
General procedures for authorised working tech-
niques.
2.
Convert the guide at the parallel cutting fence to a
narrow guide edge.
3.
Adjust the parallel cutting fence to the desired meas-
urement.
4.
Lock the sliding table into a center position.
5.
Place the workpiece against the parallel cutting
fence.
6.
Switch on the circular saw.
7.
Switch the scoring unit on, if necessary.
8.
Feed the work-piece constantly past the circular saw,
keeping your fingers balled into a fist.
Fig. 9-8: Cutting battens
