57
!
"
§
$
Panel Saw
K3 basic/K3 winner/K3 e-classic
9.5.5 Trimming
1.
Take note of general procedures for authorised
working techniques.
2.
Assembling the trimming shoe:
• Thread the trimming shoe into the sliding table
grooves using locking plates.
• Clamp the trimming shoe onto the sliding table
using thumb screws.
3.
Undo the sliding table catch and pull the sliding ta-
ble back completely.
4.
Place the unfinished plank, with the hollow side fac-
ing downwards, onto the sliding table and clamp in
the trimming shoe.
5.
Switch on the circular saw.
6.
Feed the workpiece constantly past the circular saw,
keeping your fingers balled into a fist.
Fig. 9-6: Trimming shoe
!
Thumb screws
"
Trimming shoe
§
Groove
$
Sliding table
Warning: Risk of injury: Trimming may only take place if using a trimming shoe!
Operation
9.5.4 Longitudinal cut
1.
Take note of general procedures for authorised work-
ing techniques.
2.
Adjust the parallel cutting fence to the desired meas-
urement.
3.
Lock the sliding table into a center position.
4.
Place the workpiece against the parallel cutting
fence.
5.
Switch on the circular saw.
6.
Switch the scoring unit on, if necessary.
7.
Feed the workpiece constantly past the circular saw,
keeping your fingers balled into a fist.
Fig. 9-5: Longitudinal cut
