60
45
°
!
"
#
Panel Saw
K3 basic/K3 winner/K3 e-classic
Operation
9.5.8 Cross-cutting at the parallel cutting fence
1.
Take note of general procedures for authorised work-
ing techniques.
2.
Adjust the parallel cutting fence to the desired meas-
urement.
3.
Set the fence plate (guide):
The rear end of the guide is abutting an axis which
starts at the leading edge of the saw blade and runs
at an 45° angle to the rear.
The work-piece can not, as a result, be clamped in-
between the fence and the saw blade.
4.
Undo the sliding table catch.
5.
Place the work-piece against the crosscut fence.
6.
Switch on the circular saw.
7.
Switch the scoring unit on, if necessary.
8.
Feed the work-piece constantly past the circular saw,
keeping your fingers balled into a fist.
!
Line
"
Saw blade
#
Guide
Fig. 9-11: Cross-cutting at the parallel cutting fence
1.
Take note of general procedures for authorised work-
ing techniques.
2.
Move the parallel cutting fence as far away as pos-
sible from the saw blade.
3.
Attach the off-cut deflector to the machine in such a
way that the sawed off pieces do not collide with the
rising part of the saw blade.
4.
Undo the sliding table catch.
5.
Place the work-piece against the crosscut fence.
6.
Switch on the circular saw.
7.
Using your left hand, press the work-piece hard onto
the crosscut fence.
8.
Feed the work-piece constantly past the circular saw,
keeping your fingers balled into a fist.
9.
Pull the work-piece a few millimeters away from the
saw blade and move the sliding table into the initial
position.
9.5.9 Cutting smaller, narrower workpieces
Fig. 9-12: Cutting smaller, narrower workpieces
