ADJUSTMENTS
AND
TESTING
ANTEA 50 BT – BTS - BTO
Doc.
10059284
Issued
12/2016
Ver.
AC
Page
24 of 25
Adjusting the squeegee
1. The rubbers must have an angle between 30° and 45°
relative to the floor and uniform along the entire length of
the squeegee.
2. Adjust the
register
inclination of the rear rubber, with
suction motor on, so that it has a uniform slope. Adjust the
screw clockwise to increase the inclination of the squeegee
in the central part. Adjust screw counterclockwise to
increase the inclination of the squeegee in the lateral side.
3. To ensure the uniformity of the adjustment of all the
rubber, act on the
knobs
for adjusting the height and the
left / right balance of the wiper to the ground.
4. Make sure that the adjustment has been securely blocked.
About 30°- 45°
Rear
rubber
Front
rubber