2016-08
7
/
12
-
-
1
-
-
1
1.5.a - AREAS WITH EXPLOSION HAZARD
It is strictly forbidden to use the machine in places where there is a risk of explosion due to
gases, vapors, fl uids, and infl ammable and explosive powders.
1.6 - USE RESTRICTIONS
-
In order to be able to reach all the control devices with ease and avoid any ergonomically
incorrect position, the operators’ height must be neither inferior to 1,50 m (60 inch) and
nor superior to 2,05 m (80 inch) (shoes included).
-
When using the machine in environments with corrosive debris or extreme climates, heavy
magnetic fi elds, saline air and brackish water, etc… please consult the sales network for
additional use/maintenance requirements.
NOTE:
The manufacturer shall not be held responsible for mechanical issues, failures, breaks
or accidents, due to the use of the machine under conditions different than those
specifi ed in “chapter 3” or elsewhere in this manual.
1.7 - CHECKS
Before beginning work,
CHECK
that all safety and emergency devices are in place, in good
condition and working properly.
Do not start the machine if any safety shield, guard, control, instrument, signal light or signal
buzzer, or other protective device, is not in place and working properly.
The following checks must be carried out:
-
Before starting the machine;
-
At regular time intervals (see chapter 5);
-
After any modifi cation or repair;
-
Also see “Preliminary checks, chapter 4”.
Safety devices check
The machine’s safety devices must be checked by properly trained technicians once every
six months.
The technician must prepare a check report at the end of the inspection.
General overhaul
Every 5000 hours of running or at least once every 5 years, the machine must be overhauled
by a workshop authorized by the manufacturer.
Summary of Contents for 900SX
Page 15: ...2016 08 12 12 1 1...
Page 18: ...2016 08 3 6 2 1 2 4 3 5...
