6.0 AMP ANGLE GRINDER 15
OPERATING INSTRUCTIONS
6. Paddle Switch
a) To unlock the switch and turn tool
on: push the “lock-off” switch
release lever forward to unlock
paddle switch, then squeeze
paddle switch
b) To switch tool “off”: release
pressure on paddle lever. The
switch is spring loaded and
will return to “off” position
automatically.
7. Grinding
WARNING:
Excessive or sudden
pressure on the wheel will slow grinding
action and put dangerous stresses on the
wheel.
CAUTION:
Never press the spindle
locking button while the wheel is rotating.
Efficient grinding is achieved by
controlling the pressure and keeping the
angle between wheel and workpiece at
10° to 15°. If the wheel is flat, the tool
is difficult to control. If the angle is too
steep, the pressure is concentrated on a small area, causing burning to the work surface.
When grinding with a new wheel, be certain to grind while pulling tool backwards until the
wheel becomes rounded on its edge. New wheels have sharp corners, which tend to “bite”
or cut into work piece when pushing forward.
WARNING:
Always disconnect the device before performing any adjustment or
maintenance operation. if the replacement of the supply cord is necessary, this has to be
done by the manufacturer or his agent in order to avoid a safety hazard.
1
2
6
A
B
7
Summary of Contents for HAAG060
Page 20: ......
