4V LITHIUM-ION SCREWDRIVER 15
TROUBLESHOOTING
Suspected malfunctions are often due to causes that the users can fix themselves.
Therefore, check the product using this section. In most cases the problem can be solved
quickly.
WARNING:
Only perform the steps described within these instructions! All further
inspection, maintenance and repair work must be performed by an authorised service
centre or a similarly qualified specialist if you cannot solve the problem yourself!
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
Tool does not work.
Battery is depleted.
Charge the battery.
Tool is over-loaded.
Release the trigger switch
and try again.
Battery is over-temperature. Turn off the tool and allow the
tool to cool.
Burned out switch.
Have the tool replaced by an
Authorized HAMMERHEAD
Service Center or Service
Station.
Bit cannot be installed.
Something is stuck in the
bit holder.
Clean the bit holder.
Bit does not fit the holder.
Use suitable bit or adapter.
To preserve natural resources, please recycle or dispose of batteries
properly. This product contains lithium-ion batteries. Local, state, or federal
laws may prohibit disposal of lithium-ion batteries in ordinary trash. Consult
your local waste authority for information regarding available recycling and/
or disposal options.
