HG2200/HG2200AT Operator’s Manual
Connect Tooling Head
82 - Burst Pipe
Burst Head
1. Pull wire cable (1) through existing utility
leaving the swaged button-end of the cable at
the installation pit.
2. Connect the burst head (3) to the product (4)
using burst head bolts (5).
3. Insert pneumatic tool (6) into product pipe and
burst head assembly.
4. Connect cable (1) to shackle (2) that has been
inserted through nose of pneumatic tool.
NOTICE:
Ensure the length of the new
pipe is long enough to replace the
length of pipe being replaced.
j57om074w.eps
1
2
3
4
5
6
Summary of Contents for HG2200
