HG2200/HG2200AT Operator’s
Manual
Each Use
112 - Service
Check Track Tension and
Condition (Tracked Unit)
Check track tension and adjust or replace before
startup and every 10 hours of operation.
To adjust:
1. Lift right track using right stabilizer.
2. Remove cover (1).
3. Place straightedge across front track span
from idler to sprocket as shown.
4. Pump EPG into fitting (2) until distance between top edge of bottom of track and straightedge (A) is
1-1/2” to 2” (37.5-50 mm).
5. Lower stabilizer.
6. Drive straight forward one machine length and check tension again.
7. Repeat the process for the left track.
Grease Take Up Drum Bearings
Grease take up drum bearings before startup and
every 10 hours of operation with EPG.
IMPORTANT:
Raise enough to allow the
track to hang freely from the machine.
A
A
11
22
j64om034w.eps
j64om035w.eps
Summary of Contents for HG2200AT
