HG2200/HG2200AT Operator’s Manual
Drive - 65
Steer Unit
Steer Unit
To steer winch unit, follow instructions for type of steering desired. See page 30 for more information.
To steer while moving forward
, move one control slightly more than the other to turn in the desired
direction. Winch unit will gradually turn to left or right.
To steer while moving backward
, move one control slightly more than the other to turn in the desired
direction. Winch unit will gradually turn to left or right.
For tight steering at low speed
, one control to reverse and one control to forward to turn in the desired
direction. Tracks will counter-rotate and turn winch unit in a tight circle.
Tips to Reduce Track Wear
Rubber tracks are best suited at soil-based job sites with minimal rock and debris. Sharp objects such as
gravel, steel shards, and broken concrete will damage rubber tracks and undercarriage components.
Excessive operation on concrete or asphalt will shorten track life. When storing your machine, keep tracks
away from rain and direct sunlight.
Wash tracks daily to remove foreign objects and abrasive soil from sprockets and idler rollers. Drive slowly
and make wide turns when possible. Regularly check undercarriage components (sprocket, rollers, idler)
for wear and damage. Maintain proper track tension. See “Check Track Tension and Condition (Tracked
To prevent premature wear, avoid the following:
•
Spinning tracks under heavy load.
•
Turning on sharp objects such as stones, stumps and debris.
•
Quick turns or “spin” turns on asphalt or concrete.
•
Driving over curbs, ledges, and sharp objects.
•
Driving with sidewall edges pressed against hard walls, curbs or other objects.
•
Driving on slopes.
•
Operating on corrosive materials such as salt or fertilizer. Wash immediately.
IMPORTANT:
These steer instructions cover the tracked unit only.
Summary of Contents for HG2200AT
