Operation
C.
Passengers
The vehicle is designed for two people only. The combined maximum
weight of the driver and the passenger should not exceed 200kg or
440lbs.
D.
Seat Adjustment
The seat should be securely fastened in the position which gives
the operator best control of the foot pedals, steering wheel, and the
remote stop button.
a.
Pull the seat adjustment handle upward to disengage the seat slide.
b.
Move the seat to the desired position.
c.
Be sure that the seat adjustment handle snaps back into place and
that seat is locked into position.
Figure 3
E. Forward and Reverse Gear
a.
Push the brake pedal down. The brake pedal must be pushed in to
change the gear settings.
b.
Push the lever forward to the "D" position for the kart to move forward.
c.
Each time you need to apply the brake to change the setting to
go backwards apply the brake and move the lever to the "R" for the
kart to go backwards,
Note
: Your kart is set up with 3 settings (See Fig.4):
"D" Forward
"N" Neutral
"R" Reverse
Figure 4
Summary of Contents for UM250IIR 2005
