*#1
:-
Owner’s Manual
36
OVERDRIVE
EFFECT
REVERB
BASS
FREQUENCY
GAIN
SECOND
MID
TREBLE
DEPTH
AMOUNT
DEPTH
PERCUSSION
MASTER EQUALIZER
ON
SOFT
FAST
THIRD
OVERDRIVE
EFFECT
REVERB
BASS
FREQUENCY
GAIN
SECOND
MID
TREBLE
DEPTH
AMOUNT
DEPTH
PERCUSSION
MASTER EQUALIZER
ON
SOFT
FAST
THIRD
LESLIE
TRANSPOSE
BYPASS
DOWN
UP
LOWER
STOP
FAST
OCTAVE
UPPER
BANK KEY
PATCH
PEDAL
LOWER
VOLUME
MASTER
VALUE
ENTER
C
DRAWBAR
MENU/EXIT
CONTROL
UPPER
LOWER
V-2
V-1
C-2
C-3
V-3
C-1
VIBRATO
C
D
D
E
F
F
G
G
A
A
B
PLAY
ADD EFFECTS
VIBRATO AND CHORUS
Adding the Classic Hammond Vibrato & Chorus to the sound.
[UPPER], [LOWER] buttons
Switches the Vibrato & Chorus e
ff
ect ON(LED lit)/OFF.
[VIBRATO AND CHORUS] knob
Select the modes in this e
ff
ect.
Th
e letter “V” means Vibrato, “C” means Chorus by
adding dry sound, and the number means width of vibrato.
NOTE: You can
fi
ne-tune the speed of Vibrato/Chorus. (P. 85)
For this example, switch “ON” the [UPPER] and select “C-3”.
LESLIE
Th
e Leslie e
ff
ect is the famous “Moving and Swirling” sound provided by rotating
horns and speakers, but executed here in the digital realm.
[FAST] button
Th
is button toggles the mode of the rotor to FAST(LED lit) or not.
[STOP] button
Th
is button sets the mode STOP(LED lit) or SLOW when the [FAST] button is o
ff
.
[BYPASS] button
To engage the Leslie e
ff
ect, press the [BYPASS] button turning the light OFF.
NOTE: These controls perform the same functions when a external Leslie speaker is connect-
ed via the 11 pin plug.
NOTE: You can
fi
ne-tune the parameters of the on-board Leslie e
ff
ect etc. (P. 86)
For this example, let’s set the status of all Leslie buttons lights to OFF.
OVERDRIVE
Th
e overdrive section adds warmth at low settings, and “grit” or distortion at higher.
[OVERDRIVE ON] button
Th
is button toggles ON(LED lit)/OFF the Overdrive e
ff
ect.
[DEPTH] knob
Adjusts the amount of Overdrive.
Th
e amount increases as you rotate the knob clock-
wise.
NOTE: You can
fi
ne-adjust the Overdrive e
ff
ect (P. 102).
MULTI EFFECT
Adjusts the amount of the Chosen Multi-e
ff
ect to be applied to the Drawbar sounds.
Th
e default settings: at “Tremolo”.
[EFFECT ON] button
Toggles the Multi-E
ff
ects send ON(LED lit) and OFF.
[AMOUNT] knob
Adjusts the amount of Multi-E
ff
ect to be applied.
Th
e amount increases as you rotate
the knob clockwise.
In this example, the Multi-E
ff
ects are not used.
Th
e Button light should be OFF.
TRY TO MAKE YOUR OWN SOUND - continued
Summary of Contents for XK-5
