*#1
:-
Owner’s Manual
80
to total silence.
DAMPER
⓮
DAMPER - UPPER (G)
⓯
DAMPER - LOWER (G)
⓰
DAMPER - PEDAL (G)
Assigns the DAMPER to the various divisions of the this keyboard, when the function
of the foot controller is set at DAMPER.
SUSTAIN
⓱
SUSTAIN LENGTH - UPPER (G)
⓲
SUSTAIN LENGTH - LOWER (G)
Sets the release rate each part, when the function of the foot controller is set at SUS-
TAIN.
Th
e setting range is 0(short) to 5(long).
NOTE: The key-click on the key released does not sound during Sustain is working.
DRAWBARS
⓳
CONTROL MODE (G)
Th
is is for switching the relationship between the Manual Keyboard Drawbars and the
Registrations.
A
/B
Each operation of the Drawbars [A
] and [B] a
ff
ects only the corresponding Adjust Presets
[A
] and [B].
The Drawbar operation is not e
ff
ective when the Preset Keys [C] -- [A] are selected, or when the
Patches are selected with the [VALUE] knob.
ALWAYS A
The operation of the Drawbar [B] is e
ff
ective when the Preset Key [B] is selected. Otherwise,
the Drawbar [A
] operation is always e
ff
ective.
⓴
ASSIGNABLE DRAWBARS (G)
Th
is is for switching whether or not to use the LOWER [B] Drawbar as an assignable
Drawbar.
In OFF the Drawbar [B] moves normally, and in ON it acts as an assignable Drawbar.
ASSIGN - FOOTAGE (G)
Th
is is for selecting the footage to assign, when the LOWER [B] Drawbar is set as the
Assignable Drawbar.
Footage selection is made not only with the [VALUE] knob but also by moving each
APPLICATION OF CONTROL
MODE
A
/B:
First prepare the Registration for chorus with
the Drawbar [A
], playing verse with the
[B] Preset Key, then make a sudden timbre
change by pressing the [A
] Preset Key upon
entering chorus.
ALWAYS A
:
In addition to above, the following operation
is possible:
To gradually change the Registration with
the Drawbar [A#], playing with the recalled
Patches with the Preset Keys [C] -- [A], or the
[VALUE] knob.
DAMPER
Or “Sustain” pedal-analogous to the RIGHT
pedal on a piano. Sounds are held when this
pedal is depressed. Called “Damper” due to
the fact that when the pedal was depressed
on a piano, the mechanism that muted or
“damped” the strings was raised, allowing the
piano strings to ring free.
SUSTAIN
Unlike synthesizer nomenclature, on the this
keyboard “Sustain” refers to note decay after
note release. On a synth envelope generator
this setting would be called “T4” or “Release”.
CONTROL - continued
❶
❷
❸
❹
❺
❻
❼
❽
❾
❿
⓬
⓭
⓮
⓯
⓰
⓱
⓲
⓳
⓴
⓫
Summary of Contents for XK-5
