HAMPTON BAY 408-179, Instruction Manual

Page 8

TROUBLESHOOTING: 

LIMITED WARRANTY

The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a 
period of three (3) years from date of purchase.  This warranty applies only to the original consumer 
purchaser and only to products used in normal use and service.  If this product is found to be defective, the 
manufacturer’s only obligation, and your exclusive remedy, is the repair or replacement of of the product at 
the manufacturer’s discretion, provided that the product has not been damaged through misuse, abuse, 
accident, modifications, alterations, neglect or mishandling.  This warranty shall not apply to any product 
that is found to have been improperly installed, set-up, or used in any way not in accordance with the 
instructions supplied with the product.  This warranty shall not apply to a failure of the product as a result of 
an accident, misuse, abuse, negligence, alteration, or faulty installation, or any other failure not relating to 
faulty material or workmanship.  This warranty shall not apply to the finish on any portion of the product, 
such as surface and/or weathering, as this is considered normal wear and tear.  

The manufacturer does not 

warrant and specially disclaims any warranty, whether expressed or implied, of fitness for a 
particular purpose, other than the warranty contained herein.  The manufacturer specifically 
disclaims any liability and shall not be liable for any consequential or incidental loss or damage, 
including but not limited to any labor/expense costs involved in the replacement or repair of said 
product. 

PRODUCT MAINTENANCE: 

1. To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use clean water, never a 

solvent) to wipe the surface of the fixture. 

2. To clean the inside of the fixture, first disconnect power to the fixture by turning off the circuit breaker 

or by removing the fuse at the fuse box.  Next, use a dry or slightly dampened clean cloth (use clean 
water, never a solvent) to wipe the interior surface of the fixture. 

3. Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry soft cloth to dust or 

wipe carefully. 

Possible Cause

Corrective Action

1. Power is off.

1. M ake sure power supply is on.

2. Faulty switch.

2. Test or replace switch.

1. Bulb is burned out

1. Replace light bulb.

2. Faulty wire connection.

2. Check wiring.

Fuse blows or circuit breaker 
trips when light is turned on.

1. Crossed wires or power wire is grounding 
out.

1. Check wire connections.

Bulb will not turn on.

Lights will not turn on.