background image

 

2

Thank you for purchasing this Hampton Bay interior rigid track kit. This product has been manufactured with the 
highest standards of safety and quality.  
 

FEATURES: 

1.    This linear track kit includes 1, 44in. track section, 1 floating canopy, 1 straight connector (for USA) and 3 Track 

Heads. 

2.

 

Track heads are multi-directional to provide light in hard to reach places. 

3.

 

This track kit can be mounted to a wall or a ceiling. 

4.

 

The floating power feed was designed to supply power anywhere along the track system. 

 

QUESTIONS, PROBLEMS, MISSING PARTS: 

Before returning to your local Home Depot, please call our Customer Service Team at 1-877-527-0313 or visit 
www.homedepot.com. Please reference SKU 413-994, UPC 008938734721 or SKU 672-841, UPC 008938234726. 
 

GENERAL: 

1.

 

Be sure to read these installation instructions and review the diagrams thoroughly before installing the track 
system.

 

2.

 

All electrical connections must be in accordance with local codes and the National Electrical Code. If you are 
unfamiliar with methods of installing electrical wiring, secure the services of a qualified licensed electrician. 

3.

 

Before starting the installation, disconnect the power by turning off the circuit breaker or by removing the 
appropriate fuse at the fuse box. Turning the power off using the light switch is not sufficient to prevent electrical 
shock. 

Note: 

The important safeguards and instructions appearing in this manual are not meant to cover all possible 

conditions and situations that may occur. It must be understood that common sense, caution and care are factors that 
cannot be built into any product. These factors must be supplied by the person(s) caring for, installing and operating 
the fixture. If at any time you are uncomfortable or are unsure of what to do, please contact a qualified licensed 
electrician for further assistance. 

 

 

IMPORTANT SAFETY INSTRUCTIONS 

WHEN INSTALLING OR USING THIS TRACK SYSTEM, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS 
BE FOLLOWED INCLUDING THE FOLLOWING: 

1.

 

Read all instructions. Save these instructions and refer to them when additions to or changes in the track 
configuration are made. 

2.

 

Do not install this lighting system in a damp or wet location. 

3.

 

Before energizing make sure that the lighting system is clear of all material which could cause a direct short and 
check all electrical connections to make sure they are secure. 

4.

 

Do not install any part of this system (TRACK) less than 7 feet (2.2m) above floor. 

5.

 

Do not install any lamps closer than 6 inches (15.25cm) from any curtain or similar combustible material. 

6.

 

For installation with EC series track only. 

7.

 

CAUTION – To reduce the risk of a burn during re-lamping, remove from the track before re-lamping. 

8.

 

This track system is not intended for the use with a power supply cord or convenience receptacle adaptor. 

9.

 

This track system is to be supplied by a single branch 120 volt circuit. 

10.

 

The track is not intended to be pendant mounted such as by a stem or cable. 

11.

 

The mounting screws are to be mounted along the track in the keyhole slots provided. 

12.

 

Disconnect electrical power before adding to or changing the configuration of the track. 

13.

 

Do not attempt to energize anything other than EC series track lighting fixtures or components on the track. To 
reduce the risk of fire and electrical shock, do not attempt to connect power tools, extension cords, appliances, etc. 
to the track. 

14.

 

CAUTION:

 Lighted lamp is hot! Do not touch lamp at any time. Use a soft cloth, Oil from skin may damage 

lamp. 

15.

 

CAUTION – 

Hot surface, keep away from curtains and other combustible materials. 

16.

 

Lamp gets hot quickly! Contact only switch or plug when turning on. Do not touch hot lamp lens. 

 

 SAVE THESE INSTRUCTIONS 

 

TOOLS REQUIRED FOR ASSEMBLY & INSTALLATION (not included): 

 
 

     

             

 

 
 Ladder             Safety goggles          Wire stripper       Gloves              Flathead screwdriver     Phillips screwdriver                      
 
 
 
Electrical tape             Drill              1/4 In. (method 1) or 5/8 In. (method 2) Drill bits                                 
                                                                   

PARTS INCLUDED FOR ASSEMBLY (parts are not to scale):

  

 

                                                                                   

  
 
                                                   

                 

x1 Canopy 

x 2 Toggle 

x1 44in. 

x3 GU10 Shielded

x1 Hardware

  x3 Track 

1 straight

 

bolts Linear Track Bulb(For USA)

Packet

Fixtures Connector

Box

Summary of Contents for 413-994
















Reviews: