7
Turn of the Century
TM
Motor
Screw
Blade Arm
Notch
Motor
Fitter Plate
Blade Screw
Blade Washer
Blade Arm
Blade
ASSEMBLY INSTRUCTIONS
Black (Hot)
Wire Connector
White (Neutral)
Bare/Green (Ground)
Black
Blue
White
Green
12
11
10. Raise the canopy, ensure the two mounting bracket
screws are aligned with the L-shaped slots in the canopy.
Then turn the canopy counter clockwise until the
mounting bracket screws are completely engaged in
the L-shaped slots. Install the two previously removed
mounting bracket screws in the round holes. Securely
tighten all four mounting bracket screws.
9. Use wire connectors to connect the fan wires to the
power supply wires according to the wiring diagram and
the following instructions:
• Connect the green wire from the upper bracket to the
bare/green (ground) supply wire.
• Connect the white wire from the fan to the white
(neutral/common) supply wire.
• Connect the black and blue wires from the fan to the
black (live/hot) supply wire.
Note:
If there is a second hot/power wire coming from
the outlet box, connect it to the Blue (light power) fan
wire for separate light and fan control.
Important:
After the connections have been made, the
wires should be turned upward and pushed carefully
up into the outlet box. Place the black and white wire
connections on opposite sides of the outlet box.
10
9
Canopy
Round
Hole
Mounting
Bracket Screw
J-shaped Slot
11. Partially insert three blade screws, along with the
blade washers, through the blade and into the blade arm.
Tighten each blade screw, starting with the one in the
middle. Repeat this step for the remaining blades and
blade arms.
Warning:
Do NOT connect to
variable speed/dimmer-style
wall control.
12. Secure the blade arm to the underside of the motor
using motor screws removed in Step 13. Secure each blade
arm to motor before moving to the next.
Note:
The notch in the fitter plate allows a Phillips
screwdriver access to motor screws.
To install the fan without the light kit, skip to step 17
.
